Table of Contents
Advertisement
12. Use the softkeys to configure the diagram to match
the test setup you have planned for your
measurement. The purpose of this block diagram is to
tell the HP 3048A:
• What hardware you will be using.
• Which instruments will be under HP-IB system
control. (The |Control| softkey enables you to specify
the control you desire for the instrument selected in
the diagram.)
• What the interconnecting signal paths will be.
13. Press
Done
when you have completed this operation.
14. To change the graph title, press the Define Graph key.
15. When you have completed the changes, press the
Done key.
Note
If you plan to use this same measurement setup again in the
future, you may want to store these parameters in a Test
File. To do this, simply re-enter the Test File menu and
position the cursor at the end of the list of files. Then enter
a name for your new file and press the
Store File key.
16. Press the
Level.
Done
key to return to the Main Software
Signal Source Applications
3-81
Advertisement
Table of Contents
