Table of Contents
Advertisement
The Measurement Application chapters in this manual
contain "test definition" examples that will help you setup
your own measurements. These examples provide the
recommended measurement type and operating parameter
entries for many of your devices.
2. Press the Next Type | key. You will see the measurement
type selection change each time you press this key.
3. Return the measurement selection to "Phase Noise
using a Phase Lock Loop".
Note
The Phase Lock Loop measurement is the technique most
commonly used for measuring the phase noise of signal
sources. Chapter 2 of this manual provides a brief overview
of the fundamentals of the Phase Lock Loop technique. You
should become familiar with these fundamentals before you
begin to set up phase noise measurements for your own
signal sources.
4. Press
menu,
Done
to return to the Measurement Definition
Getting Started
1-17
Advertisement
Table of Contents
