Xerox 4110 Customer Release Notes page 11

Page 11
PPML jobs
To print a duplex PPML job correctly with Folding set to Tri fold "C" or Tri fold "Z," select
Letter SEF or A4 SEF as the Page Size.
Double (Left or Top) stapling setting
When you select the Double (Left or Top) setting for the Stapling Mode option, your job is
stapled on the left side of the pages, not at the top.
Invalid Z-Fold constraint
When you select Z-Fold as an option, an invalid constraint message for A3SEF paper appears.
To avoid this, select the page size before you select Z-Fold.
Suspend on Mismatch jobs
When a Suspend on Mismatch job is resolved, and you click Print, the job in the Active Jobs
panel disappears and is immediately sent to the Printed Jobs panel before it is actually printed.
Although this occurs, the job prints successfully.
Stapling and Punching constraints
Stapling and punching require that a finisher is installed on the printer. The finisher type
determines the number of holes (2, 3, or 4) punched.
Use the Punch Position print option to specify the position of punching. Use the Stapler
Mode print option to specify the number (1 or 2) and position of staples.
Part Number: 45051581