Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS – FENDER ASSEMBLY, TANDEM AXLE
1. Review all directions and diagrams provided before starting fender installation.
2.
Center fender above tire using block to maintain the proper height. Fender should be
approximately 6" above tire to allow for suspension movement (see Fig. A). A maximum
width of 48" from center of the truck to the outside edge of the fender should be maintained
(see Fig. A).
3. Place fender bracket weldments (Pt.
No. 10H74) on fender. Position the
brackets to avoid any mounting
obstacles on hoist and/or truck chassis.
4. Mark mounting holes through the
fender bracket weldment onto the
fender. Remove the bracket and drill
Ø7/16" holes in fender (see Fig. C).
5. Attach fender bracket weldments to
ender using fasteners provided.
6. Weld mounting plates (Pt. No. 21H37) to
fender tubes (Pt. No. 21H61).
7. Position fender tubes with mount plates
on hoist main frame; align with fender
bracket weldments. (NOTE: Fender tube
length may need to be modified to fit
specific application.)
8. Weld fender tubes to hoist main frame. If
attaching the fender tubes to the truck
chassis, an additional mount plate may
need to be fabricated so the assembly can
be bolted to the truck chassis.
9. Attach fender bracket weldment (Pt. No.
10H74) to mounting plate (Pt. No. 21H37)
using fasteners provided (see Fig. C).
2.7.INS.ACC.11H14
Section II: Installation - Accessories
Figure A
Figure B
2-27
Advertisement
Table of Contents
