Table of Contents
Advertisement
LIFT BAR DETAIL
NOTE:
1.
A STRUCTURAL JIB CONTACT POINT LOCATED AS LOW AS ALLOWABLE ON THE CONTAINER FRONT IS REQUIRED.
2.
WELD HOOK GUARD TO BODY OR ADD STRUCTURAL SUPPORT AS NEEDED FOR THE APPLICATION.
3.
THIS DRAWING PROVIDES THE CRITICAL SUB-FRAME DIMENSIONS FOR COMPATABILITY WITH THE SWAPLOADER
HOOK LIFT HOIST. IT IS THE SUB-FRAME SUPPLIER'S RESPONSIBILITY TO PROVIDE A SUB-FRAME OF SUFFICIENT
CAPACITY WHICH PROPERLY SUPPORTS THE BODY/CONTAINER WHEN USED WITH THE HOOK LIFT HOIST.
4.
SWAPLOADER MANUFACTURED 200 SERIES A-FRAMES REQUIRE A 6 INCH LONGSILL HEIGHT.
2.0.INS.SL-222
200 SERIES SUB-FRAME CRITIICAL DIMENSIONS
200 SERIES SUB-FRAME DIMENSIONS
HOIST COMPATABILITY
SL-2418HD
SL-225
SL-180/185/212/214/240
SL-205
SL-220/222
Section II: Installation
A
84 1/8" [2137 mm]
24" [610 mm]
110 3/4" [2813 mm]
36" [915 mm]
111 3/4" [2839 mm]
48" [1220 mm]
122 3/4" [3118 mm]
36" [915 mm]
123 3/4" [3143 mm]
48" [1220 mm]
B
2-13
Advertisement
Table of Contents
