Table of Contents
Advertisement
1. Fill the hydraulic tank with hydraulic oil (see oil specification in Section IV: Maintenance.)
2. Prime the pump by loosening the clamp on the suction hose at the pump. Pull the hose
back off the fitting till the air is bled from the line. Push the hose back on the fitting and
retighten the clamp.
3. Engage the P.T.O. and run the engine at idle (700 to 900 RPM). Operate the cylinders at
full stroke five to ten times to bleed the air from the lines and cylinders. The cylinders were
filled with oil during testing at the factory, but some seepage may have occurred during
shipping and installation. Refill the hydraulic tank, if needed, during this sequence and do
not let the pump run without oil.
4. Check for leaks and tighten fittings as
necessary.
5. Verify the movement of the control levers
corresponds to the movement of the
cylinders per the figure below.
6. Install all safety decals and product decals
as shown on Pg. 1-5 after final installation
and painting have been completed.
7. Fill out the Product Registration form online
at
https://www.swaploader.com/warranty-
registration/
NOTE:
FAILURE TO FILL OUT AND SUBMIT PRODUCT REGISTRATION WITHIN 15 DAYS OF INSTALLATION MAY POSSIBLY
VOID THE WARRANTY.
CAUTION
2-12
START UP PROCEDURE
The SwapLoader hoist must be used with bodies or containers that properly
fit the front hook and the rear hold-downs (see Subframe Critical Dimensions
on Pgs. 2-13 to 2-15). If possible, pick up one of the containers that will be
used with the SwapLoader hoist and verify the following:
Outside dimensions of the long sills match the guiding rollers on the
hoist.
The front hook dimensions are correct for the hoist.
The rear hold-downs of the container latch into the hold-downs on
the hoist.
Check for any interference between the container and any part of the
hoist (i.e.: Hydraulic tank, hydraulic tubing or hose, hydraulic valve,
etc.)
Section II: Installation
2.0.INS.SL-222
Advertisement
Table of Contents
