Efco SWAPLOADER SL-222 Parts And Operation Manual page 15

64H34) and the rear brackets (Pt. No. 64H37). Locate the mount brackets on the side of the
hoist as indicated in Fig. B. Adjust locations as necessary to miss chassis suspension,
brackets, etc. When positioning the brackets allow for mounting the control valve assembly
and the hydraulic tank. You should consult the truck chassis supplier for any limitations
regarding drilling mount holes in the truck chassis frame rails. Typically, the holes must be at
least 2 3/4" from the top of the truck chassis rails (reference Fig. C, D & E). Once the
locations of the mount brackets have been determined, use the mount brackets as a
template for marking the mounting holes in the truck chassis frame rails. Drill the 21/32"
diameter holes required and
attach the brackets to the
truck chassis with the 5/8"
diameter bolts, washers, and
locking hex nuts provided.
Torque to 220 ft.lb.
3. Bolt the mount brackets to the
hoist main frame as indicated
on Fig. C, D and E. You may
need to modify the mount
brackets or add shim plates
to allow for variances in the
width of the truck chassis as
well as to allow for top rivets,
stepped channels, etc.
Figure D
2.0.INS.SL-222
Section II: Installation
Figure C
Figure E
2-3