Advertisement
1.
The protection fuse and the domestic wiring are suitable to carry the total electric
load of the cooker.
2.
The electricity supply network (mains) has an efficient earth connecting
according to the established rules and existing regulations.
3.
The cooker wire is long enough to reach the socket from where your cooker is
situated.
THE MANUFACTURER WILL NOT BE RESPONSIBLE FORANY ACCIDENT
CAUSED BY NON OBSERVANCE OFSAFETY INSTRUCTION.
GAS HOSE CONNECTION
First connect one end of the rubber hose to the gas regulator and tighten it with a hose
clamp. The other end should be pushed tightly into the gas hose connector. Tighten it with
a hose clamp, make sure that both ends are tighten otherwise gas might leak and this could
be dangerous. Make sure all the control knobs are in the "off" position before connecting
the gas supply. Connect the gas regulator to the LPG tank and your units ready for use.
Whenever connecting the hose to the cooker please ensure:
1.
The hose does not exceed a length of 1 meter.
2.
The hose must not be very tight or twisted and must not show any sharp bends or
kinks. If there is a leak don't repair but replace it.
3.
The hose must not touch the back of the cooker.
Upon completing the installation, check and make sure that all pipes and hoses
are connected correctly. Always use soapy water to check gas leaking. For safety
reasons we would advise you to inspect and change the rubber hose for the gas
connection yearly.
WARNING - USE THE CORRECT DOMESTIC GAS REGULATOR.
DO NOT USE AN INDUSTRIAL GAS REGULATOR.
DOMESTIC GAS REGULATOR FOR LPG 30mbar.
CHILD SAFETY
This appliance has been designed for use by adults. Take care, therefore that
children do not attempt to play with it.
6
Advertisement
