Using Autocal Or Colorcal; Calibrating With Colorwise Pro Tools And Autocal Or Colorcal - Xerox DocuColor 3535 Color Manual

2

2-23 Using AutoCal or ColorCal

Using AutoCal or ColorCal
AutoCal and ColorCal allow you to calibrate the Fiery without using an additional
spectrophotometer or densitometer. Instead, these methods use the copier's built-in
scanner to measure toner density values.
AutoCal is compatible with earlier Fiery servers. AutoCal and ColorCal have the
following differences:
• Scanner calibration—ColorCal lets you calibrate the scanner (copier feeder) using
the Kodak Color and Gray Scale strips. AutoCal lets you calibrate the copier using
the Kodak Gray Scale strip; scanner calibration is not available.
• Measurement page—For ColorCal, square black-and-white and color patches are
randomly printed on the ColorCal Measurement Page. This allows ColorCal to be
less influenced by copier conditions, providing greater accuracy in color
reproduction and calibration.
You can perform AutoCal or ColorCal calibration from ColorWise Pro Tools.
For troubleshooting during the AutoCal procedure, see the
To calibrate using AutoCal or ColorCal, you will need the Kodak Gray Scale
N :
OTE
strip included in the customer media pack that came with your Fiery.

Calibrating with ColorWise Pro Tools and AutoCal or ColorCal

T
O PREPARE FOR CALIBRATION
1. On the Copier Control Panel, press the Access button (key icon).
2. Enter your password.
3. Choose Confirm.
4. Choose System Settings>System Settings>Scan Mode Setting>Others.
5. For Color_space, select 1 (dRGB).
6. Choose Close until the System Settings screen appears. Then choose Exit.
Job Management Guide.