Xerox CopyCentre 133 Supplementary Manual page 12

Quick Scan to SMB Setup
Files can be scanned on the multifunction device and routed on to a server or a client using SMB protocol.
Directory structures (repositories) need to be created on the server to hold the scanned documents.
See also:
System Administrator Guide: Contains detail concerning Scan to SMB setup.
User Guide: Contains information on how to set up templates and repositories.
Prerequisites for Scan to SMB Setup
1. Confirm that an existing operational network utilizing TCP/IP is available.
2. SMB Server exists and is running.
3. Repository (folder) needs to be created on the SMB server to hold the scanned document.
4. Confirm that the following ports are enabled:
a. TCP/IP Port
b. SMB Port
c. SNMP Port
d.
SOAP Port
Data to Set Up Scan to SMB
Server IP address
Server Shared Name
Repository -- directory path,
where the document will
be stored on the SMB server
SMB Login/password
information
Kerberos IP Address
Install
Requirement Comments
Required This is the IP address of the SMB server.
Required This is the name assigned to the shared folder on the
SMB server.
Required This is the location or path of the directory for saving
scanned documents.
Optional This is required, if the SMB server requires login/password
authentication. Most SMB servers require a login/password.
Optional If Remote Authentication is required, then Kerberos needs to
be enabled.
®
Xerox WorkCentre
10
Pro 123/128/133
Quick Scan to SMB Setup