Table of Contents
Advertisement
DISASSEMBLY & ASSEMBLY PROCEDURE
MODEL RAS-10XH1, RAS-14XH1
1. Front panel
(1) Hold the handheld parts of the front panel and lift it.
When opening or closing the front panel, do not hold the
movable panel.
Movable panel
Front panel
(2) Move the farthest part of the right arm outwards and
remove the shaft.
(3) Move the left arm outwards, remove the left shaft, pull it
towards you, and remove it.
Arm
Installation instructions
1) Insert the shaft of the left arm of the front panel along the
step in the body until shaft enters the hole.
2) Insert the shaft of the right arm of the front panel along
the step in the body until the shaft enters the hole.
3) After ensuring that the front panel is securely installed,
close the front panel.
Arm
Step
Handheld parts
Push
Push
Push
Arm
Step
2. Fancy cover
(1) Remove the screw cover from the bottom of the fancy
cover and remove the screws.
(2) Pull the bottom of the fancy cover towards you and
remove it.
(3) Unscrew the terminal block cover and the left and right
part of the fancy cover.
Left part of
Screws
the fancy cover
(4) Place your hand on the left part of the fancy cover, pull the
bottom slightly towards you, and turn it upwards and remove it.
(5) Place your hand on the right part of the fancy cover, pull the
bottom slightly towards you, turn it upwards, and remove it.
At that time, remove the upper lug by inserting a screwdriver or
something similar into it.
Installation instructions
1) Ensure that the dew pan and cleaner are securely
installed.
2) After fitting the left and right parts of the fancy cover into
the body, fit the upper lugs
3) Tighten the screws in the terminal block cover and the left
and right parts of the fancy cover securely.
4) Fit the bottom of the fancy cover, tighten the screws, and
Arm
install the screw cover.
Fix the upper lugs
– 79 –
Screws
Terminal block cover
Bottom part of
the fancy cover
(x
2) securely.
(x
2)
Right part of
Screws
the fancy cover
Lug
Advertisement
Table of Contents
