Hitachi RAS-10XH1 Service Manual page 53

Stainless steel plasma air purification operation
AIR PURIFICATION
button
START/STOP
button
Remote control
"AIR PURIFICATION" lit
Operation lamp
Mist and air
purification lamp
Indoor unit
Operating according to the settings made by remote control
Open
Front panel
Closed
Vertical vane
Tool position
Product operation
Product operation
status
ON
Electrical dust
collector
OFF
Notes: (1) Pressing the "air purification" button on the remote control unit will activate
the stainless steel plasma air purification.
(2) If the stainless steel plasma air purification operation is set while the product
is stopped, turning on the electrical dust collector will activate the product with
wind feed.
(3) Setting the stainless steel plasma air purification operation while the product
is operating will turn on the electrical dust collector. At the same time, the
product will operate in the operation mode selected by remote control.
ION MIST button
START/STOP button
Operation lamp
Mist and air
purification lamp
Indoor unit
Front panel
Operating according to the settings made by remote control
Vertical vane
Product operation
status
Operating according to the settings made by remote control
Electrical dust
collector
Notes:
Ion mist operation
Operating according to the settings made by remote control Operating according to the settings made by remote control
Open
Closed
Tool position Operating according to the settings made by remote control
Product operation
ON
OFF
(1) Pressing the ION MIST button on the remote control unit will activate
the ion mist operation and perform the stainless steel plasma air purification.
During the ion mist operation, the electrical dust collector will be on.
(2) Setting the ion mist operation while the product is stopped will activate the
product with wind feed.
(3) Setting the ion mist operation while the product is running will activate the
product in the operation mode selected by remote control.
– 69 –