Daily Use - Electrolux EDH804H5WB User Manual

16 www.electrolux.com

9. DAILY USE

9.1 Start a program without
delay start
1. Prepare the laundry and load the
appliance.
CAUTION!
Make sure that when you close
the door, the laundry does
not get caught between the
appliance door and the rubber
seal.
2. Press the on/off button to activate
the appliance.
3. Set the correct program and options
for the type of load.
The display shows the program
duration.
Real drying time will depend
on type of the load (quantity
and composition), the room
temperature and the humidity of
your laundry after spin drying
phase.
4. Press the Start/Pause touch button.
The program starts.
9.2 Starting the program with
delay start
1. Set the correct program and options
for the type of load.
2. Press the delay start button again
and again until the display shows
the delay time you want to set.
You can delay the start of a
program from a minimum of
30 minutes to a maximum of
20 hours.
3. Press the Start/Pause touch button.
The display shows the countdown of
the delay start.
When the countdown is completed, the
program starts.
9.3 Change a program
1. Press the on/off button to deactivate
appliance
2. Press the on/off button to activate
the appliance.
3. Set the program.
9.4 At the end of the program
When the program is completed:
•
An intermittent acoustic signal
operates.
•
The display shows
•
The indicator
•
The indicators
may come on.
•
The Start/Pause indicator is on.
The appliance continues to operate
with the anti-crease phase for
approximately 30 minutes or more if
Extra Anticrease option was set (see
chapter Option -Extra Anticrease).
The anti-crease phase reduces
creasing.
You can remove the laundry before the
anti-crease phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed.
When the anti-crease phase is
completed:
•
The display still shows
•
The indicator
•
The indicators
remain on.
•
Start/Pause indicator goes off.
1. Press the on/off button to deactivate
the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Possible causes of unsatisfactory
drying results:
is blink.
Filter and Tank
.
is off.
Filter and Tank