Table of Contents
Advertisement
Available languages
Available languages
touchpads until the child lock indi-
cator goes off.
6.2 Water hardness and
conductivity
Water hardness is different for different lo-
cations. Water hardness has an effect on
the water conductivity and on the con-
ductivity sensor of the appliance. If you
know, the value of the water conductivity
you can adjust the sensor in order to have
better drying results.
Adjusting the conductivity sensor
1. Use the programme knob to set any
programme.
7. DAILY USE
Before you use the appliance for the
first time
1. Clean the appliance drum with a moist
cloth.
2. Start a short programme (e.g. 30 mi-
nutes) with moist laundry.
7.1 Starting a programme
without delay start
1. Prepare the laundry and load the ap-
pliance.
2. Set the correct programme and op-
tions for the type of load.
• The display shows the programme
duration.
3. Press the Start/Pauze (Start/Pause)
touchpad, the programme starts.
CAUTION!
Make sure that when you close
the door, the laundry does not
catch between the appliance door
and the rubber seal.
7.2 Starting the programme with
delay start
1. Set the correct programme and op-
tions for the type of load.
2. Press the delay start button again and
again until the display shows the delay
time you want to set.
2. Press and hold touchpads (A) and (B)
at the same time until one of the these
indicators comes on:
•
(low <300 μS/cm)
•
(moderate 300-600 μS/cm)
•
(high >600 μS/cm)
3. Press the touchpad (E) again and
again until the indicator of the correct
level comes on.
4. To confirm the adjustment, press and
hold touchpads (A) and (B) at the
same time for approximately 2 sec-
onds.
• You can delay the start of a pro-
gramme from a minimum of 30 mi-
nutes to a maximum of 20 hours.
3. Press the Start/Pauze (Start/Pause)
touchpad, the countdown starts. The
display shows the countdown of the
delay start.
• When the countdown is completed,
the programme starts.
7.3 Change a programme
1. Turn the Programme knob to
2. Set the programme.
7.4 At the end of the
programme
When the programme is completed,
• An intermittent acoustic signal oper-
ates.
• The indicator
flashes.
• The indicator
comes on.
• The Start/Pauze (Start/Pause) indicator
is on.
The appliance continues to operate with
the crease guard phase for approximately
other 30 minutes.
The crease guard phase removes creases
from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
ENGLISH
23
OFF
Advertisement
Chapters
Table of Contents
