Zanussi MWi 771 Instructions Manual page 7

The furniture in the kitchen must be
structurally sound and sited to support the
weight of the oven; the column must be
rigidly fixed to the wall or to the adjacent
furniture.
Make the electrical connections as
previously described.
THIS APPLIANCE MUST BE
EARTHED.
Before the appliance is connected check
that: the fuse and domestic installation are
suitable to carry the electric load of this
appliance (see rating plate); the power
supply is properly earthed according to
existing rules and regulations.
THE MANUFACTURERS DISCLAIM
ANY RESPONSIBILITY SHOULD
THESE SAFETY INSTRUCTIONS NOT
BE CARRIED OUT.
Important
After installation and electrical connection
of the appliance, place the cable in such a
way that it cannot at any point reach a
temperature of 50*C above the ambient
temperature.
IT IS IMPORTANT THAT MEANS OF
ELECTRICAL ISOLATION SHOULD
BE SITED WITHIN 2 METRES OF THE
BUILT-IN POSITION OF THE
MICROWAVE OVEN.
Installation instructions
1. Fix the two supports onto the bottom of
recess with four screws each (Fig 3).
2. Fit the foam rubber strips onto the lips
on the under-side of the steam ventilation
cowling (Fig 4). Then position this on the
microwave to ensure the two holes in the
cowling align with the corresponding holes
in the back panel of the microwave. Secure
with the two screws provided, ensuring the
cowling has achieved an air-tight fit.
3. Place the oven on the runners and push
it completely toward the back. Be sure that
the front feet are securely located as in
(Fig 5).
4. Place the frame in position and fix it to
the cabinet with four screws. Check and
see if the door opens completely (Fig 6).
Fig. 3
Fig. 4