Zanussi MWi 771 Instructions Manual page 6

Table of Contents

Advertisement

Positioning
The MWi''1 is supplied ready to operate in
the free-standing mode. Should you wish to
use it in this mode, simply place it on a flat,
level surface and remove all materials from
the oven interior. There must be at least
2.5 em/1 inch of clearance at the top,
4cm/11 inches at the back and 2.5cm/1
inch each side.
NOTE: Do not store cookbooks or this
instruction book inside or underneath the
oven. .
Electrical Connection
For your convenience and safety your new
Zanussi microwave comes ready fitted with
a moulded flex and plug. All you have to do
is to push the plug into a 13 amp power
socket and switch on. However, if for some
reason you need to replace this plug with
one of your own, you will find the wires
inside the flex are colour coded as follows:
GREEN AND YELLOW - EARTH
BLUE
-NEUTRAL
BROWN
-LIVE
If you fit your own plug, the colours of the
wires in the mains lead of your appliance
may not correspond with the markings
identifying the terminals in your plug, this
is what you have to do:
Connect the green and yellow (earth) wire
tothe terminal in the plug which is marked
with the letter E! or the earth symbol
,
or colour coded green, or green and yellow.
Connect the blue (neutral) wire to the
terminal in the plug which is marked with
the letter 'N' or coloured black.
Connect the brown (live) wire to the
terminal which is marked with the letter 'L'
or coloured red.
Fuses
The appliance's moulded on plug is supplied
fitted with a 13 amp BS1362 fuse. If this
fuse blows you can replace it in the
following way:
— Remove the plug from the power socket
and use a small screwdriver to lever out the
red plastic fuse carrier located between the
plug's prongs, together with the old fuse.
Fit it with a new 13 amp fuse and clip it
back into the plug. Make sure your new
fuse is 'ASTA' approved. If the carrier is
damaged you can get a new one from your
local Zanussi Service Agent.
Building-in the Microwave Oven
The microwave oven can be built-in into a
kitchen wall unit recess. The recess in the
kitchen unit must be isolated from the other
recesses in the column. (Fig 1 and 2).
_Supports for
oven location
Fig. 1
Fig. 2

Advertisement

Table of Contents
loading

Table of Contents