Universal Remote Control R7 Owner's Manual page 31

Hide thumbs Also See for R7:

Table of Contents

The R7 Remote Control

SECTION 2: Erasing АП Learned Commands from

One Component Mode

This function allows vou to erase all the learned commands from one

component. For example, if vou want to erase all learned commands

on the TV component button because vou bought a new TV, the

process is verv simple.

STEP 1: Press and hold both the desired component button and the

ENTER (ENT) button at the same time for about 3 seconds until the

component LED light turns on.

IMPORTANT: If vou don't press a button within 20 seconds, the

LED light will turn off and exit the set-up mode and vou will need

to start over.

PAUSE

Button

ENTER (ENT)

Button

STEP 2: Press and hold both the desired component button vou

want to erase and the PAUSE

button for about three seconds, until

the component LED light blinks twice to confirm the erasure.

STEP 3: To exit, press and hold both the component button and the

ENTER

(ENT) button until the component LED light blinks three

times.

Table of Contents

Need help?

Do you have a question about the R7 and is the answer not in the manual?