Download Print this page

Universal Remote Control R7 Owner's Manual page 29

Hide thumbs Also See for R7:

Table of Contents

Erasing Commands - Оуегмем

You can erase a single learned command, all learned commands in

each component mode, SimpleSound

programming,

MacroPower

commands, or re-set the remote to original factory default settings, if

desired.

SECTION 1: Erasing a Single Learned Command

STEP

1: To erase a single command,

press and hold both the

component button and the ENTER (ENT) button together for about 3

seconds until the component LED light turns on.

COMPONENT

Buttons

ENTER (ENT)

Button

UNIVERSAL"

IMPORTANT: If you don't press a button within 20 seconds, the

LED light will turn off and exit the set-up mode and you will need

to start over.

Table of Contents

Need help?

Do you have a question about the R7 and is the answer not in the manual?