Universal Remote Control R7 Owner's Manual page 12

Hide thumbs Also See for R7:

Table of Contents

IMPORTANT: Vou now have 20 seconds to рейогт the next

step while vou are in set-up mode. If vou don't press a button

within 20 seconds, the LED light will turn off and exit the set-

up mode and vou will need to start over.

STEP 5: Point the remote toward the Component, (in this example

the TV), and punch in the 3-digit-code that vou wrote down for that

specific Component. Use the Number buttons 0-9 on the remote to

punch in the code. The TV LED light will blink each time a number is

pressed. This lets you know that the number has been successfully

entered.

Press Number

buttons to add

3-digit codes

Number

Buttons

If the 3-digit code number you just punched in is the correct number,

the component you are trying to program will turn off. If it did not turn

off, continue entering code numbers from your list until the TV turns

off.

IMPORTANT: If you tried all the set-up codes in the list and the

component still did not turn off, either the Auto-Search Method

(page 12) or the Learning Method (page 14) will help you.

Table of Contents

Need help?

Do you have a question about the R7 and is the answer not in the manual?