Section 2: Pre-Programmed Auto Search Method - Universal Remote Control R7 Owner's Manual

SECTION 2: Pre-Programmed Auto-Search Method
The Auto-Search Method is а мау vou can scan through other
codes in the table to find the right code for vour component.
STEP 1: Using vour old remote, turn on the component vou want to
program with the R7, let's sav vour TV.
STEP 2: Now, press down on the Component button, (in this case
the button that savs TV), and the SELECT (SEL) button at the
same time. Hold them both down for 3 seconds until the TV
component button LED light turns on.
IMPORTANT: If you don't press a button within 20 seconds, the
LED light will turn off and exit the set-up mode and vou will need
to start over.
STEP 3: Press the UP ARROW button once. Each time the Up
Arrow is pressed, the code will count up one code number and
send a Power OFF signal. When the correct code is sent out, the
component will turn off.
UP ARROW
Button