Universal Remote Control R7 Owner's Manual page 26

Hide thumbs Also See for R7:

Table of Contents

The R7 Remote Control

STEP 4: Press the component button vou want to set-up.

STEP 5: Point the R7 at the component vou want to program and

enter the 3-digit set-up code listed in the Code Tables. Use the

Number buttons 0-9 on the remote to enter the code. The AUX LED

light will blink once for each button pressed. Once vou enter the

correct code number, the component will turn off. If the component

does

not turn off, press the next code numbers

listed for your

component until it turns off.

STEP 6: Now, turn on the component and test the the VOLUME

and

CHANNEL buttons (for TV) or the PLAY and STOP buttons (for VCR

and DVD) to make sure that they all work. If any of the functions does

not work properly, repeat Step 5 using the next code number listed for

your component until you find a perfect match.

STEP 7: Once you've found a correct code, you just have to save it.

Press the component button you just programmed, one more time to

store the code number. The component LED light will blink three

times to confirm that the code was successfully stored.

Table of Contents

Need help?

Do you have a question about the R7 and is the answer not in the manual?