Do you have a question about the R7 - SPECS SHEET and is the answer not in the manual?
Questions and answers
John
March 17, 2025
How to add Dish
1 comments:
Mr. Anderson
March 17, 2025
To add a Dish receiver to the R7 Universal Remote Control, follow these steps:
1. Insert Batteries: Ensure two AA batteries are correctly installed in the remote. 2. Enter Programming Mode: - Press and hold the button for the component you want to program (e.g., "SAT" for Dish). - Wait until the LED light under the button glows red. 3. Enter the Dish Code: - Use the number keypad to enter one of the Dish codes: 122 or 167. - The LED should blink to confirm the code entry. 4. Test the Remote: - Point the remote at the Dish receiver and press the power or channel buttons. - If the receiver responds, the setup is complete. - If not, repeat the steps with the other Dish code. 5. Exit Programming Mode: - Press the "Enter" or "OK" button to save the code.
Your R7 remote should now control the Dish receiver.
This answer is automatically generated
Related Manuals for Universal Remote Control R7 - SPECS SHEET
Need help?
Do you have a question about the R7 - SPECS SHEET and is the answer not in the manual?
Questions and answers
How to add Dish
To add a Dish receiver to the R7 Universal Remote Control, follow these steps:
1. Insert Batteries: Ensure two AA batteries are correctly installed in the remote.
2. Enter Programming Mode:
- Press and hold the button for the component you want to program (e.g., "SAT" for Dish).
- Wait until the LED light under the button glows red.
3. Enter the Dish Code:
- Use the number keypad to enter one of the Dish codes: 122 or 167.
- The LED should blink to confirm the code entry.
4. Test the Remote:
- Point the remote at the Dish receiver and press the power or channel buttons.
- If the receiver responds, the setup is complete.
- If not, repeat the steps with the other Dish code.
5. Exit Programming Mode:
- Press the "Enter" or "OK" button to save the code.
Your R7 remote should now control the Dish receiver.
This answer is automatically generated