Disassembling The Electronic Circuit Boards - Wellness Technogym Trainer Point Service And Maintenance Manual

7.2. DISASSEMBLING THE ELECTRONIC CIRCUIT BOARDS

Figure 7.2-1
Page 7.2
TRAINER POINT: Service & Maintenance Manual - rev. 1.2
Carry out the procedure described in paragraph
7.1. "Disassembling the housing".
Place the housing on a work bench / flat surface.
To disassemble the POWER SUPPLY a:
1. Disconnect connector b.
2. Unscrew the 4 screws which fix it to the
cover using a medium Phillips screwdriver.
3. Remove the power supply board.
To disassemble the KEY READER c:
4. Disconnect the connector.
5. Unscrew the 2 screws which fix it to the
cover using a medium Phillips screwdriver.
6. Remove the fixing block.
7. Remove the circuit board.
To disassemble the TLCBR d:
8. Disconnect the 2 connectors.
9. Unscrew the 3 screws which fix it to the
cover using a medium Phillips screwdriver.
10. Remove the circuit board.
To reassemble the ELECTRONIC CIRCUIT
BOARDS, carry out reversal of the above
procedure.