Table of Contents
Advertisement
®
R&S
SZM
6.2.3
RF In connector
2.92 mm coaxial connector with an impedance of 50 Ω for RF signal input.
Connect the signal generator or any other device providing the RF input signal to
the "RF In" connector on the R&S SZM. Use a cable equipped with an appropri-
ate connector.
Do not overload the input. The value for maximum input power is indicated next to
the "RF In" connector or see the data sheet. See also
tions for test
setup",
How to:
Chapter 5.8, "Connecting to RF
6.2.4
Power supply connector
Main power supply connector for the external DC power supply. Use only the DC
power adapter provided with the R&S SZM to connect the instrument to an AC
power supply. The supported voltage is indicated on the instrument, next to the
connector.
How to:
Chapter 5.5, "Connecting to
6.2.5
USB connector
Type-B USB 2.0 input connector for control functions by the signal generator.
How to:
Chapter 5.7, "Connecting to
Manual 1179.3967.02 ─ 02
on page 17.
power",
USB",
Chapter 5.4, "Considera-
In",
on page 20.
on page 18.
on page 19.
Instrument tour
Rear panel
28
Advertisement
Table of Contents
