R&S SZM Manual page 23

®
R&S SZM
b) Set the frequency multiplying factor on the signal generator.
Note: You can set the RF output power of the R&S SZM only when the
mechanically controlled attenuator option is installed. It is not possible to
adjust the R&S SZM output power if no attenuator or the electronically control-
led attenuator option is installed.
● R&S SZM with the mechanically controlled attenuator option:
You can find the setting values of the micrometer screw of the mechani-
cally controlled attenuator option for a specific R&S SZM output power and
frequency on a USB flash drive delivered with the option.
See Chapter 6.1.1, "Output power adjustment
● R&S SZM without the mechanically controlled attenuator option:
Measure the output level of the R&S SZM at the desired frequency. For
level correction add external devices, e.g. attenuators, to your test setup.
6. Switch on the RF output of the signal generator.
The test setup is ready for operation.
Manual 1179.3967.02 ─ 02
Preparing for use
Completing the test setup
screw", on page 24.
23