Rear Panel - R&S SZM Manual

®
R&S SZM
Figure 6-2: Assignment of the test port adapter
1, 3 = Alignment pin
2, 4 = Hole for IEEE alignment pin
The test port adapters are similar in design for all frequency bands. Refer to the
data sheet for more details on the type of waveguide.
Connect the DUT to this test port adapter.
A DUT with thin pins reduces the alignment and stability. If possible, use two
additional pins above and below the waveguide cross-section to compen-
sate for the reduced alignment.
Dismounting the test port adapter
If the R&S SZM is equipped with the optional test port adapter (TPA), you can dis-
mount the TPA using a hex ball driver (accessory). Without the TPA, the calibra-
tion is no more valid (e.g. R&S SZM output power). Take this into account when
connecting the DUT directly to the R&S SZM without the TPA in between.
6.2

Rear panel

This section provides an overview of the rear panel elements of the R&S SZM.
Manual 1179.3967.02 ─ 02
1
2
3
4
Instrument tour
Rear panel
26