Advertisement
Quick Links
TOYOTA
MY22 RAV4
Preparation
Part Number:
PT949-08231 (Dashcam)
PT949-48210 (Y-Harness)
Dashcam Kit Contents
Item #
Quantity Reqd.
1
1
2
1
3
1
4
1
5
1
6
2
7
1
Y-Harness Kit Contents
Item #
Quantity Reqd.
1
1
2
2
3
4
Additional Items Required For Installation
Item #
Quantity Reqd.
1
1
2
1
Conflicts
N/A
Recommended Tools
Personal & Vehicle
Protection
Seat Protection
Dash Protection
Special Tools
RAV22-0020
Install Aid
Installation Tools
Panel Tool
Socket Wrench
Torque Wrench
Hooked Panel Tool
Needle Nose Pliers
Special Chemicals
VDC Approved Cleaner
General Applicability
Only Models with Electronic Rear View Mirror
Recommended Sequence of Application
Item #
Accessory
1
Y-Harness (PT949-48210)
2
Dashcam (PT949-08231)
Issue: G 11/07/2023
Description
Dashcam Main Unit
SD Card Holder
SD Card (16 GB)
Window Mounting Plate
Foam Tape
Cable Ties
Quick Start Guide
Description
Mirror Patch Y-Harness
Foam Tape
Cable Ties
Description
PT949-08231 (Dashcam Unit)
PT949-48210 (Y-Harness)
Notes
Notes
For Port Installations Only
The legacy part number
PT949-IAD0H also valid and
can be used.
Notes
With 10 mm Socket
With 10 mm Socket
For Sun Visor Clip Removal
Notes
To Clean Windshield
*Mandatory
Page 1 of 17 pages
2022-
DASHCAM
Legacy Part Numbers: PT949-08230 (Dashcam)
Vehicle Service Parts
Item #
Quantity Reqd.
1
Up to 4 pcs
2
3
4
Kit Service Parts
Item #
Part Number
1
PT949-08210-AA
2
PT949-60220-AB
3
PT949-60220-AC
4
PT949-08210-AD
Legend
STOP: Damage to the vehicle may occur. Do not
proceed until process has been complied with.
OPERATOR SAFETY: Use caution to avoid risk of
injury.
CAUTION: A process that must be carefully observed
in order to reduce the risk of damage to the
accessory/vehicle and to ensure a quality installation.
TOOLS & EQUIPMENT: Used in Figures calls out the
specific tools and equipment recommended for this
process.
REVISION MARK: This mark highlights a change in
installation with respect to previous issue.
SAFETY TORQUE: This mark indicates that torque is
related to safety.
REGULATORY MARK: This mark indicates the
component is related to regulatory compliance.
(Digital Video Recorder)
PT949-08210 (Dashcam)
(may be required for reassembly)
Description
Roof Console Clips if damage
occurs during removal.
P/N: 90467-09240
(may be required in future)
Description
Camera Unit + SD
SD Card 16GB Industrial
Sd Card Holder Assembly
Window Plate with Tape
Advertisement
Related Manuals for Toyota PT949-08231
Summary of Contents for Toyota PT949-08231
- Page 1 Additional Items Required For Installation Item # Quantity Reqd. Description STOP: Damage to the vehicle may occur. Do not PT949-08231 (Dashcam Unit) proceed until process has been complied with. PT949-48210 (Y-Harness) OPERATOR SAFETY: Use caution to avoid risk of Conflicts injury.
-
Page 2: Disconnect Battery
Vehicle Disassembly/Reassembly (panel removal, part storage, etc.). Electrical Component Disassembly/Reassembly (battery disconnection, connector removal, etc.). • Please see your Toyota dealer for a copy of this document. 1. Disconnect Battery (a) Protect the fender / bumper before starting. (b) The engine components and coolant may be hot. -
Page 3: Vehicle Protection
TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure Hybrid Version Battery Disconnection: (i) Do NOT touch or disconnect high voltage systems on a Hybrid Vehicle. Only disconnect the 12V Battery. (j) The 12V Battery on the Hybrid vehicle is located in the rear cargo compartment on the right-hand side. - Page 4 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure 4. Install Windshield Base Plate STOP: The front windshield must be at least 50°F (10°C). (a) For PPO Installations, please use 3D hard template “H” with the part number “RAV22-0020”...
- Page 5 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure For Dealer Installations / No 3D Hard Template Available: (g) Using scissors, cut the paper template as indicated. For PPO Installations, please use 3D hard template provided. (h) Referencing the TSS cover, align to the indicated line and affix the template to the windshield using tape.
- Page 6 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure 6. Remove Roof Map Light Console (a) Remove the roof console by pulling down firmly on the rearward edge (towards the rear of the vehicle). Pull down firmly to release rear 2 clips first then again pull down to unhook the 2 clips at the front edge (Fig.
- Page 7 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure (b) Holding the TSS Cover firmly with both hands, move it downwards towards the windshield wiper cowl area by approximately 10 mm, without fully removing it. This is to get better access to remove the cover around the mirror (Fig.
- Page 8 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure 8. Install the Y-Harness (a) Disconnect the mirror power harness in on the release tab. The mirror harness is the 10-pin connector, outboard to the passenger side. (Fig. 8-1), (Fig. 8-2) Fig.
- Page 9 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure (4) Pull the remaining slack harness back into the headliner / map light console area as per the image. (Fig. 8-5) Fig. 8-5 9. Route Dashcam Harness through the Headliner (a) From the driver’s side of the windshield,...
- Page 10 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure (d) Connect the Dashcam pigtail harness to the newly fitted Y-harness that was fitted in step 7. (Fig. 9-4) Fig. 9-4 (e) Apply the supplied Foam Tape to insulate the connectors from rattles.
- Page 11 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure 11. Fitting the Dashcam to Base Plate NOTE: The Hang Tag that is attached to the Dashcam is only to be removed by the end user. As the camera turns on with...
- Page 12 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure (c) Hook the Dashcam wire extension cover hooks into the leading edge of the headliner. (Fig. 11-5) Fig. 11-5 (d) Swing the Dashcam unit up towards the base plate. Check for alignment of the 4 T-hooks.
- Page 13 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure 12. Route / Bundle Wire Harness (a) Before proceeding with securing the harness, confirm that both connector pairs and fuse holders have been protected with the provided foam tape. Use the provided foam tape to minimize any potential rattle concerns.
- Page 14 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure 13. Reinstall Overhead Console (a) Re-connect harness for the overhead console, test map lights and sunroof control if equipped. (Fig. 13-1) (b) Check all console clips are in good condition and are present on the console.
- Page 15 (Fig. 17-3) (d) Optional: Use the Live View feature of the Toyota Integrated Dashcam phone application to confirm the view angle if compensating for other accessories / obstructions.
- Page 16 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Procedure Page 16 of 17 pages Issue: G 11/07/2023...
- Page 17 TOYOTA MY22 RAV4 2022 - DASHCAM (Digital Video Recorder) Checklist - these points MUST be checked to ensure a quality installation. Check: Look For: Accessory Function Checks Removed items have been discarded & Verify parts replaced items are in place...