KTM 150 EXC 2023 Setup Instructions page 22

3 WORK
3.6
3.7
20
Installing the fork legs
S04824-13
S03475-11
E00375-11
Installing the front wheel
Warning
Danger of accidents Oil or grease on the brake discs reduces the braking effect.
–
Always keep the brake discs free of oil and grease.
–
Clean the brake discs with brake cleaner when necessary.
Main work
–
Position the fork legs.
1
Bleeder screws are positioned toward the front.
Info
The rebound damping is located in right fork leg REB
(red adjuster). The compression damping is located in
left fork leg COMP (white adjuster).
Grooves are milled into the side of the upper end of the
fork legs. The second milled groove (from the top) must
be flush with the upper edge of the upper triple clamp.
–
2
Tighten screws .
Guideline
Screw, top triple
clamp
–
3
Tighten screws .
Guideline
Screw, bottom triple
clamp
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front M8
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
Finishing work
–
Install the front wheel. (
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
M8 20 Nm (14.8 lbf ft)
M8 15 Nm (11.1 lbf ft)
25 Nm (18.4 lbf ft)
Loctite
5
.
p. 20)
p. 30)
p. 30)
4
.
® 243™