Table of Contents
Advertisement
Important Safeguards
15. Power Lines — An outside antenna system should
b. If any liquid has been spilled onto, or objects
not be located in the vicinity of overhead power
have fallen into the video unit.
lines or other electric light or power circuits, or
c. If the video unit has been exposed to rain or
where it can fall into such power lines or circuits.
water.
When installing an outside antenna system,
d. If the video unit does not operate normally by
extreme care should be taken to keep from
following the operating instructions. Adjust only
touching such power lines or circuits as contact
those controls that are covered by the operating
with them might be fatal.
instructions, as an improper adjustment of other
16. Overloading — Do not overload wall outlets and
controls may result in damage and will often
extension cords as this can result in a risk of fire or
require extensive work by a qualified technician
electric shock.
to restore the video unit to its normal operation.
17. Objects and Liquids — Never push objects of any
e. If the video unit has been dropped or the cabinet
kind into this video unit through openings as they
has been damaged.
may touch dangerous voltage points or short out
t. When the video unit exhibits a distinct change in
parts that could result in a fire or electric shock.
performance — this indicates a need for service.
Never spill liquid of any kind onto the video unit.
20. Replacement Parts — When replacement parts are
18. Servicing — Do not attempt to service this video
required, be sure the service technician has used
unit yourselt as opening or removing covers may
replacement parts specified by the manufacturer or
expose you to dangerous voltage or other hazards.
have the same characteristics as the original part.
Refer all servicing to qualified service personnel.
Unauthorized substitutions may result in fire,
19. Damage Requiring Service — Unplug this video
electric shock or other hazards.
unit from the wall outlet and refer servicing to
21. Safety Check— Upon completion of any service or
qualified service personnel under the following
repairs to this video unit, ask the service technician
conditions:
to perform safety checks to determine that the
a. When the power-supply cord or plug is
video unit is in safe operating order.
damaged.
Precautions
USE & LOCATION
* TO AVOID SHOCK HAZARD ... Your Camcorder and power supply should not be exposed to rain or moisture.
Do not connect the power supply or operate your Camcorder if it gets wet. Your Camcorder has been designed
for outdoor use, however it is not designed to sustain direct exposure to water, rain, sleet, snow, sand, dust, or
a direct splashing from a pool or even a cup of coffee. This action could permanently damage the internal parts
of your Camcorder. Do not attempt to disassemble this unit. There are no user serviceable parts inside. Unplug
your Camcorder from the power supply before cleaning.
* DO NOT AIM YOUR CAMCORDER AT THE SUN OR OTHER BRIGHT OBJECTS.
* DO NOT LEAVE THE CAMCORDER WITH THE EVF AIMED DIRECTLY AT THE SUN AS THIS MAY CAUSE
DAMAGE TO THE INTERNAL PARTS OF THE EVF.
* DO NOT EXPOSE YOUR CAMCORDER TO EXTENDED HIGH TEMPERATURE ... Such as, in direct sunlight,
inside a closed car, next to a heater, etc... This action could permanently damage the internal parts of your
Camcorder.
* AVOID SUDDEN CHANGES IN TEMPERATURE ... If the unit is suddenly moved from a cold place to a warm
place, moisture may form on the tape and inside the unit.
* DO NOT LEAVE YOUR CAMCORDER
OR THE POWER SUPPLY TURNED ON WHEN NOT IN USE.
* STORAGE OF YOUR CAMCORDER ... Store and handle your Camcorder in a manner that will not subject it to
unnecessary movement (avoid shaking and striking). Your Camcorder contains a sensitive pick-up device which
could be damaged by improper handling or storage.
CARE
* TO CLEAN YOUR CAMCORDER ... Do not use strong or abrasive detergents when cleaning your Camcorder
body.
* TO PROTECT THE LENS ... Do not touch the surface of the lens with your hand. Use a commercial camcorder
lens solution and lens paper when cleaning the lens. Improper cleaning can scratch the lens coating.
* TO PROTECT THE FINISH OF YOUR CAMCORDER
... Before handling your Camcorder, make sure your
hands and face are free from any chemical products, such as suntan lotion, as it may damage the finish.
peu
Bu
Advertisement
Table of Contents
