Table of Contents
Advertisement
Built-in Auto Light
Using the Built-
To improve recording indoors or outdoors in
dim tighting conditions.
DANGER:
When replacing the bulb, use only lamp bulbs
(PART NO. VLLW0015) supplied by
Panasonic to reduce the risk of fire.
Use a cloth or tissue when handling the bulb
as finger oils will decrease the bulb life.
To prevent possible burn hazard, remove the
lens cover and allow the lamp to cool before
replacing.
IRE TTB BIT
Before you begin...
» Connect the Camcorder to a power source.
» Set the POWER switch to CAMERA.
Set the LIGHT switch to AUTO.
The built-in light automatically turns on and
off depending on lighting conditions.
Or set LIGHT to ON/OFF to turn the light
on and off manually.
ZD will appear in the EVF while the light is
turned on.
Caution:
This light becomes hot during operation.
Make sure nothing covers the Light during
operation.
Before you begin...
* Set the POWER switch to OFF.
* When ordering replacement bulbs, use PART
No. VULS0001
I Push in on the both sides of the lens
cover to unlock and pull it straight
out from the Camcorder.
2 Using Tweezers or Needle-nose
pliers, carefully remove the bulb from
the Camcorder.
* If you have trouble replacing the bulb,
please take the unit to your nearest
service center for assistance.
Using a clean cloth or tissue, replace
the bulb.
A. ous the lens cover straight back
into place.
Note:
* Using the light reduces battery operating time.
* If using the Built-in Light in a hot environment
for an extended period of time, be sure to
provide ventilation.
* Using the Built-in Light when the Camcorder is
powered by a car battery may shorten bulb life.
* Be sure LIGHT switch is set to OFF when not
in use or before placing Camcorder into an
optional carrying case.
* Be very gentle when handling the bulb.
Excessive force may cause the bulb to crack.
Advertisement
Table of Contents
