Precautions Aaa A - Panasonic Plamcorder PalmSight PV-L671 Operating Instructions Manual

Table of Contents

Advertisement

Important Safeguards
15. Power Lines — An outside antenna system
b. If any liquid has been spilled into, or
should not be located in the vicinity of overhead
objects have fallen onto, the video unit.
power lines or other electric light or power
c. If the video unit has been exposed to rain
circuits, or where it can fall into such power
or water.
lines or circuits. When installing an outside
d. If the video unit does not operate normally
antenna system, extreme care should be taken
by following the operating instructions.
to keep from touching such power lines or
Adjust only those controls that are covered
circuits as contact with them might be fatal.
by the operating instructions, as an improper
16. Overloading - Do not overload wall outlets
adjustment of other controls may result in
and extension cords as this can result in a
damage and will often require extensive
risk of fire or electric shock.
work by a qualified technician to restore the
17. Objects and Liquids — Never push objects
video unit to its normal operation.
of any kind into this video unit through
e. If the video unit has been dropped or the
openings as they may touch dangerous
cabinet has been damaged.
voltage points or short out parts that could
f. When the video unit exhibits a distinct
result in a fire or electric shock. Never spill
change in performance - this indicates a
liquid of any kind onto the video unit.
need for service.
. 18. Servicing — Do not attempt to service this
20. Replacement Parts — When replacement
video unit yourself as opening or removing
- parts are required, be sure the service
, Covers may expose you to dangerous voltage
technician has used replacement parts
or other hazards. Refer all servicing to
specified by the manufacturer or have the
qualified service personnel.
same characteristics as the original part.
19. Damage Requiring Service — Unplug this
Unauthorized substitutions may result in fire,
video unit from the wall outlet and refer
'
electric shock or other hazards.
servicing to qualified service personnel under
— 24. Safety Check — Upon completion of any
the following conditions:
service or repairs to this video unit, ask the
a. When the power-supply cord or plug is
service technician to perform safety checks
damaged.
l
to determine that the video unit is in safe
operating order.
Precautions
USE & LOCATION
;
:
* TO AVOID SHOCK HAZARD ... Your Camcorder and power supply should not be exposed to rain or moisture.
Do not connect the power supply or operate your Camcorder if it gets wet. Your Camcorder has been designed for
outdoor use, however it is not designed to sustain direct exposure to water, rain, sleet, snow, sand, dust, or a direct
splashing from a pool or even a cup of coffee. This action could permanently damage the internal parts of your
Camcorder. Do not attempt to disassemble this unit. There are no user serviceable parts inside. Unplug your
Camcorder from the power supply before cleaning.
* DO NOT AIM YOUR CAMCORDER AT THE SUN OR OTHER BRIGHT OBJECTS.
* DO NOT LEAVE THE CAMCORDER WITH THE EVF AIMED DIRECTLY AT THE SUN AS THIS MAY CAUSE
DAMAGE TO THE INTERNAL PARTS OF THE EVF.
* DO NOT EXPOSE YOUR CAMCORDER TO EXTENDED HIGH TEMPERATURE ... Such as, in direct sunlight,
inside a closed car, next to a heater, etc... This action could permanently damage the intemal parts of your
Camcorder.
* AVOID SUDDEN CHANGES IN TEMPERATURE ... If the unit is suddenly moved from a cold place to a warm
place, moisture may form on the tape and inside the unit.
* DO NOT LEAVE YOUR CAMCORDER OR THE POWER SUPPLY TURNED ON WHEN NOT IN USE.
* STORAGE OF YOUR CAMCORDER ... Store and handle your Camcorder in a manner that will not subject it to
unnecessary movement (avoid shaking and striking). Your Camcorder contains a sensitive pick-up device which
could be damaged by improper handling or storage.
CARE
* TO CLEAN YOUR CAMCORDER ... Do not use strong or abrasive detergents when cleaning your Camcorder
body.
* TO PROTECT THE LENS ... Do not touch the surface of the lens with your hand. Use a commercial camcorder
lens solution and lens paper when cleaning the lens. Improper cleaning can scratch the lens coating.
* TO PROTECT THE FINISH OF YOUR CAMCORDER ... Before handling your Camcorder, make sure your hands
and face are free from any chemical products, such as suntan lotion, as it may damage the finish.

Advertisement

Table of Contents
loading

Table of Contents