Table of Contents
Advertisement
Camera Recording
Programmed Recording
You can program the Camcorder to start
and stop recording at a preset time. You
can also do an Interval Recording which
allows you to record 5 or 10 second
intervals per minute.
RECORD/
PAUSE
10MIN. — 20MIN. — 30MIN. —TO TAPE END
INTERVAL *?
5 SEC/MIN.
INTERVAL *?
10SEC/MIN,
7
*1 Interval
5 SEC/MIN:
A 5 second recording is performed
each minute.
*2 Interval 10 SEC/MIN:
A 10 second recording is performed
each minute.
Note:
* The start time cannot be set for over 24
hours in advance from the current time.
* The Camcorder will automatically shut
itself off when the tape reaches its end or
12 hours after an Interval recording is
started.
+ Set the POWER switch to OFF to cancel
the Programmed Recording feature.
Before you begin...
* Connect the Camcorder to a power source.
For extended periods of recording, it is
recommended to use the AC Adaptor for a
power source.
* Insert a cassette with record tab (see page 12).
* Set the POWER switch to CAMERA.
I Press the MENU button to display
the MENU mode. Press UP A or
DOWN Y repeatedly to select
;
A
12
UTO/MANUAL
: PUSH
V/A KEY
: PUSH DISPLAY KEY
END
: PUSH MENU
KEY
2 Press the DISPLAY button to display
the current time in the EVF.
To change the start time, press the
DISPLAY button repeatedly. Each
press increases
the time by 30
minutes.
SIEGE
10:20PM
REC TIME ; 10MIN.
SELECT
: PUSH
W/a KEY
SET
: PUSH
DISPLAY
KEY
START
: PUSH
REC/PAUSE
CANCEL
: PUSH
MENU
KEY
10:20:00PM
3 Press DOWN Y to select GEAM.
Press the DISPLAY button repeatedly
to select one of the recording lengths
shown at left.
START ; 10:30PM
GPS;
10MIN.
SELECT : PUSH Wiad KEY
: PUSH DISPLAY KEY
SET
START
; PUSH REC/PAUSE
CANCEL : PUSH MENU KEY
10:20:00PM
If you want to cancel the setup, press
the MENU button twice.
Ane: setting the START and REC
TIME, press the REC/PAUSE
button
to place the
Camcorder in
stand-by
mode.
STAND-BY
START; 10:30PM
REC TIME ; 10MIN.
10:20.00PM
JUN
11998
The Camcorder will automatically start
recording at the preset time and turn
itself off when the recording is finished.
27
Advertisement
Table of Contents
