Table of Contents
Advertisement
Change the PIN code
1
Select [Menu] > [Answ. Machine] >
[Remote access] > [Change PIN], then
press [OK] to confirm.
2
Enter the old PIN, then press[OK] to
confirm.
3
Enter the new PIN code, then press [OK]
to confirm.
4
Enter the new PIN code again, then press
[Save] to confirm.
The setting is saved.
Access the answering machine
remotely
1
Make a call to your home number with a
touch tone phone.
2
Enter # when you hear the announcement.
3
Enter your PIN code.
You now have access to your
answering machine, and you can now
listen to the new messages.
Note
• You have 2 chances to enter the correct PIN
code before your phone hangs up.
4
Press a key to carry out a function. See the
Remote access commands table below for a
list of available functions.
Note
• When there is no message, the phone hangs up
automatically if no key is pressed for 8 seconds.
30 EN
Remote access commands
Key
Function
1
Listen to the previous message.
2
Listen to messages.
3
Skip to the next message.
6
Delete the current message.
7
Switch the answering machine on
(not available when you listen to the
messages).
8
Stop listening to the message.
9
Switch the answering machine off.
(not available when you listen to the
messages).
Behavior of the LED indicator on the
base station
The table below shows you the current status
with different LED indicator behavior on the
base station.
LED
Message status
indicator
Steady on •
There is no new message and
the memory is not full.
•
The handset is switched on.
•
Enter the paging mode.
Flashing
•
There is a new message and the
memory is not full.
•
There is an incoming call.
•
Recording an incoming
message/announcement.
•
Message playback.
•
Remote access/listen to
messages from the handset.
Flashing
•
There is no new message and
(Fast)
the memory is full.
•
Enter the registration mode.
Advertisement
Table of Contents
