Axis P32 Series Manual page 14

AXIS P32 Dome Camera Series
Configure your device
Detect tampering with input signal
This example explains how to send an email when the input signal is cut or short-circuited. For more information about the
I/O connector, see page 64.
1. Go to System > Accessories and turn on Supervised.
Add an email recipient:
1. Go to System > Events > Recipients and add a recipient.
2. Type a name for the recipient.
3. Select Email.
4. Type an email address to send the email to.
5. The camera doesn't have it's own email server, so it has to log into another email server to send mails. Fill in the rest of the
information according to your email provider.
6. To send a test email, click Test.
7. Click Save.
Create a rule:
1. Go to System > Events > Rules and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under I/O, select Supervised input tampering is active.
4. Select the relevant port.
5. In the list of actions, under Notifications, select Send notification to email and then select the recipient from the list.
6. Type a subject and a message for the email.
7. Click Save.
Send an email automatically if someone spray paints the lens
Activate the tampering detection:
1. Go to System > Detectors > Camera tampering.
2. Set a value for Trigger delay. The value indicates the time that must pass before an email is sent.
3. Turn on Trigger on dark images to detect if the lens is sprayed, covered, or rendered severely out of focus.
Add an email recipient:
4. Go to System > Events > Recipients and add a recipient.
5. Type a name for the recipient.
6. Select Email.
7. Type an email address to send the email to.
8. The camera doesn't have it's own email server, so it has to log into another email server to send mails. Fill in the rest of the
information according to your email provider.
9. To send a test email, click Test.
10. Click Save.
14