Axis P32 Series Manual page 11

AXIS P32 Dome Camera Series
Configure your device
4. Go to Video > Stream > General and increase Compression.
5. Go to Video > Stream > Zipstream and do one or more of the following:
Note
The Zipstream settings are used for both H.264 and H.265.
- Select the Zipstream Strength that you want to use.
- Turn on Optimize for storage. This can only be used if the VMS supports B-frames.
- Turn on Dynamic FPS.
- Turn on Dynamic GOP and set a high Upper limit GOP length value.
Note
Most web browsers don't support H.265 decoding and because of this the device doesn't support it in its web interface.
Instead you can use a video management system or application that supports H.265 decoding.
Set up network storage
To store recordings on the network, you need to set up your network storage.
1. Go to System > Storage.
2. Click
3. Type the IP address of the host server.
4. Type the name of the shared location on the host server under Network share.
5. Type the username and password.
6. Select the SMB version or leave it on Auto.
7. Select Add share without testing if you experience temporary connection issues, or if the share is not yet configured.
8. Click Add.
Record and watch video
Record video directly from the camera
1. Go to Video > Image.
2. To start a recording, click
If you haven't set up any storage, click
network storage on page 11
3. To stop recording, click
Watch video
1. Go to Recordings.
2. Click
Add network storage under Network storage.
.
again.
for your recording in the list.
and . For instructions on how to set up network storage, see Set up
11