Update; Update All - HP Integrity rx3600 Installation Manual

Seg Bus Dev Func
1 51 4 0
1 20 1 0
The identification information from this list is used to designate which controller is to be updated.

UPDATE

NOTE: The saupdate utility program file (saupdate.efi) must be located in the same file system
as the firmware files.
saupdate UPDATE [ <seg:bus:dev:func>] [smartarray_firmware_file]
For example, to update the controller at segment 1, bus 51, device 4, function 0 from the example
output above, enter a command at the EFI Shell prompt as in this following example:
fs0:\> saupdate UPDATE 1:51:4:0 CYBORG234.BIN
Replace CYBORG234.BIN with the name of your firmware file.
The following screen displays:
*************************************************************
Smart Array Offline Firmware Update Utility
Version: 1.04.12.00
(C) Copyright 2004 Hewlett Packard Development Company L.P.
*************************************************************
Updating controller in Seg: 1, Bus: 51, Dev: 4, Func: 0
Current firmware version 1.92
Percentage completed: 100%
Activating firmware now, this may take several minutes.
Resetting and reinitializing controller.
Retrieving firmware version, this may take several minutes.
Current controller firmware version is 2.34.
The UPDATE command will not prevent downgrade to a lower firmware version.
After updating the firmware, cycle the power on the system and on any external JBODS connected
to the Smart Array HBAs.
Exit status codes0: Success

UPDATE all

When "all" is specified, the utility downloads the firmware image to all the controllers to which
the firmware image applies and updates the remaining controllers. If an update operation fails for
a controller, the utility still updates the remaining controllers.
The example below shows the command to update all controllers for which the firmware image
file applies. The controllers for which the firmware image is not applicable are skipped. In this
example, the Smart Array P600 controller is updated, and the Smart Array 5300 is skipped:
fs0:\> saupdate UPDATE all CYBORG234.BIN
Replace CYBORG234.BIN with the name of your firmware file.
The following screen displays, showing the controllers that are updated and skipped:
*************************************************************
Smart Array Offline Firmware Update Utility
Version: 1.04.12.00
(C) Copyright 2004 Hewlett Packard Development Company L.P.
*************************************************************
Updating controller in Seg: 1, Bus: 51, Dev: 4, Func: 0
Current firmware version 1.92
Description
HP Smart Array P600
HP Smart Array 5300
Version
1.92
3.54
Core I/O Card Configuration 65