Maxview COMBO/50 Installation & User's Instructions page 40

Troubleshooting and FAQ's - For TV reception & Signal Booster
1. I have no picture on my TV or the picture is breaking up/freezing?
- Ensure all connections are correct
- Ensure the Variable Signal Booster power LED is on
- Try adjusting the gain control on the Variable Signal Booster (turn to right to increase gain.
We suggest you start with 100% gain and reduce if in a high strength area)
- To maximise the number and quality of channels found, you will need to retune your TV/Freeview box
when changing locations, the aerial is likely to be picking up channels from different transmitters
2. Power LED is not lit on my Variable Signal Booster
- Ensure power switch is in the on position
- Ensure the power source is connected correctly
- Check the inline fuse in the power cable
3. Should I be using the Variable Signal Booster (VSB) in Line with my Roam Combo 5G Combo?
We recommend always using the VSB in-line as this will boost the signal quality significantly.
However, in some areas where the signal strength is good, it may not be necessary to use the VSB
4. Can I change the length of the cable supplied with my Roam Combo 5G Combo?
- Yes, you can shorten the cable by cutting it to the required length and refitting the F connector.
- Details on how to fit the F connector on page 9
- You can lengthen the cable by using a back to back connector and some additional F cable or a flylead
- Please note, longer cable may introduce signal losses and reduce signal quality
5. How should I clean my Roam Combo. Do I need to carry out any maintenance?
- The Roam Combo has been designed to be maintenance and trouble free
- If you do wish to clean your 5G Combo Antenna, use a sponge with mild soap and a minimal amount of water
- Never use a powerful flow of water, power washer or solvents to clean
40