Finishing Work And Cleaning - WAGNER AirCoat GM 4600AC-H Translation Of The Original Operating Manual

EDITION 05/2011
OPERATING MANUAL
6.1

FINISHING WORK AND CLEANING

Exploding gas/ air mixture!
Danger to life from flying parts and burns
SIHI_0008_GB
Cleaning agent in the air duct!
Functional faults caused by swollen seals
Always keep the attachment of the spray gun held downwards when cleaning.
Ensure that neither paint nor cleaning agent enters the air duct.
When taking a break from work or when stored for a longer period, the spray gun has
to be positioned correctly with the attachment pointing downwards.
SIHI_0005_GB
Explosive atmosphere!
Explosive gases are produced when aluminium comes into contact
with halogenized hydrocarbons
SIHI_0009_GB
Note:
Methylene chloride is not recommended as a fl ushing or cleaning solvent with this gun or
any system components.
1. Relieve spray gun and unit pressure.
2. Secure gun with trigger safety catch.
3. Connect cleaning supply.
4. Remove AirCoat jet nozzle and clean separately (see chapter 5.4.3).
5. Pressurize the cleaning supply to approx. 4 MPa; 40 bar; 580 psi and thoroughly fl ush
the spray gun.
6. Relieve spray gun and unit pressure.
7. Secure gun with trigger safety catch.
8. Clean gun body with a cleaning agent recommended by the manufacturer, and dry
with a cloth.
Part No. DOC394861
Never spray into a closed container.
Earth the container.
CAUTION
WARNING
To clean aluminium, do not use liquids containing halogenized
hydrocarbons.
DANGER
GM 4600AC
25