Removing And Fitting The Appliance Door - NEFF B45E54 0 Series Instruction Manual

Preparation and switching on
EasyClean® only starts when the cooking compartment is cool.
ã=
Risk of scalding and surface damage!
Never pour water into the cooking compartment when it is hot.
Water vapour will be created and the enamel may be damaged
because of the change in temperature.
Remove the accessories from the cooking compartment.
1.
Carefully pour 0.4 litres of water (not distilled water) with
2.
some detergent into the base trough of the cooking
compartment (Fig. A).
Close the appliance door.
3.
Switch on EasyClean®.
>
4.
"'† appears in the temperature display.
If, after EasyClean is switched on,
alternately in the temperature display, the cooking
compartment is not completely cooled.
Wait until the cooking compartment has cooled down and
switch EasyClean® on again.
Once EasyClean® has finished the cooking compartment
light switches on. A signal sounds.
Press the clock function button to exit the clock function.
KJ
5.
$
Cleaning up and switching off
Do not leave the remaining water in the cooking compartment
for a long time (e.g. overnight).
Open the appliance door and remove the remaining water
1.
with an absorbent sponge cloth (Fig. B).
Clean the cooking compartment with a sponge cloth, a soft
2.
brush or a plastic saucepan scrubber.
Note: You can remove any remaining, persistent residue with
a glass scraper for glass ceramic.
Remove limescale with a cloth soaked in vinegar, then wipe
3.
with clean water and rub dry with a soft cloth. Remember to
dry under the door seal.
Turn the operating mode selector back to the
4.
After cleaning, leave the appliance door ajar in the stop
5.
position (approx. 30°) for approx. 1 hour to allow the enamel
surfaces in the cooking compartment to dry thoroughly.
Rapid drying
After cleaning, leave the appliance door ajar in the stop
1.
position (approx. 30°).
Set CircoTherm® at 50 °C.
3
2.
After 5 minutes, switch off the appliance and close the
3.
appliance door.

Removing and fitting the appliance door

You can remove the appliance door to clean it more
thoroughly.
ã=
Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always fully turn the two locks for fitting and removing the
appliance door.
22
or and appear
• œ "'†
%
Û position.
ã=
Risk of injury!
If the appliance door has been removed without turning both
locking levers to their limit stops, the hinge may snap shut. Do
not reach into the hinge. Call the after­sales service.
Removing the appliance door
Open the left and right-hand hinge lock (Fig. A).
1.
To do this, push the hinge lock (Fig. B) fully upwards on both
sides with a screwdriver.
$
Hinge lock closed (Fig. C)
Hinge lock open (Fig. D)
&
Open the appliance door a little (Fig. E).
2.
Using a coin, fully turn both the left and right-hand locks on
3.
the inside of the appliance at the bottom (Fig. F).
Left lock: clockwise
Right lock: anti-clockwise
(
Close the appliance door a little, until you feel the locks
4.
engage.
The door can now no longer be opened or closed.
Lift the door handle slightly using both thumbs and lift out the
5.
appliance door (Fig. G).
*
%
'
)