Siemens SK26E222EU Information For Use page 45

Fault
Excessive formation of
foam occurs.
Fault
Special salt refill indic-
ator lights up.
Refill indicator for spe-
cial salt does not light
up.
Refill indicator for
rinse aid lights up.
Refill indicator for
rinse aid does not
light up.
Fault
Water is left in the ap-
pliance at the end of
the programme.
Appliance cannot be
switched on or oper-
ated.
Appliance does not
start.
Cause and troubleshooting
Remove the rinse aid with a cloth.
▶
Detergent or appliance care product used causes ex-
cessive foaming.
Change the brand of detergent.
▶
Cause and troubleshooting
Insufficient special salt.
Add Special salt → Page 23.
▶
Sensor does not detect special salt tablets.
Do not use special salt tablets.
▶
Water softening system is switched off.
Set the water softening system.
▶
Insufficient rinse aid.
Add Rinse aid → Page 24.
1.
Set the amount of rinse aid to be dispensed.
2.
Rinse aid system is switched off.
Set the amount of rinse aid to be dispensed.
▶
Cause and troubleshooting
Filter system or area under the filters is blocked.
Clean the Filters → Page 34.
1.
Clean the Wastewater pump → Page 48.
2.
Programme has not yet ended.
Wait until the programme ends or cancel the pro-
▶
gramme with Reset.
→ "Terminate programme", Page 31
▶
Appliance functions have failed.
Pull out the mains plug or switch off the fuse.
1.
Wait at least 2 minutes.
2.
Connect the appliance to the power supply.
3.
Switch the appliance on.
4.
The mains fuse has tripped.
Check the relevant fuse.
▶
Mains cable is not inserted.
Check whether the socket works.
1.
Check whether the mains cable is properly inserted
2.
in the socket and on the rear of the appliance.
Troubleshooting en
45