Safety instructions Warning Knives and other utensils with sharp points Delivery must be placed in the cutlery basket with the points downwards or horizontally on – Check the packaging and dishwasher immediately for damage caused in the knife shelf *. transit.
Damage Getting to know your – The appliance may be repaired and appliance opened up by a technician only. To do this, disconnect the appliance from the Diagrams of the control panel and the power supply. Pull out the mains plug interior of the appliance can be found in or switch off the fuse.
Water hardness table Water softening system :DWHU +DUGQHVV PPROO 6HW YDOXH To ensure good washing results, the KDUGQHVV UDQJH RQ WKH dishwasher requires soft water, i.e. YDOXH PDFKLQH containing low amounts of lime, otherwise &ODUNH white limescale will be deposited on the ¯¯...
Switching off salt refill indicator/ Special salt $ water softening system If the salt refill indicator ` is impaired Using special salt (e.g. when using combined detergents Always refill with special salt immediately containing salt component), it can be before switching on the appliance. This switched off.
Setting amount of rinse aid Rinse aid % The amount of rinse aid dispensed can be set from : to : As soon as the rinse-aid refill indicator X Do not change the amount of rinse aid is lit on the fascia, there is still a rinse-aid unless streaks (select lower setting) or reserve of 1 –...
Unloading the dishwasher Utensils Hot utensils are sensitive to shock! Therefore, when the programme ends, Not suitable leave the utensils to cool down in the – Cutlery and utensils made of wood. dishwasher until they can be handled. – Delicate decorative glasses, craft and Basket 1B antique utensils.
Folding spikes * Detergent * depending on model The spikes can be folded down to improve You can use tablets as well as powder arrangement of pans, bowls and glasses. or liquid detergents for dishwashers, but never use washing up liquid. The dosage can be individually adjusted with powder or a liquid detergent according to the degree of soiling.
Adding detergent Combination detergent – If the detergent dispenser 1R is still Apart from conventional detergents (Solo), closed, press the lock 1Z to open the a number of products are offered with detergent dispenser. additional functions. These products contain not only the detergent but also Pour detergent into the dry detergent rinse-aid and salt replacement substances dispenser 1R only (insert tablet flat,...
Overview of programmes The max. possible number of programmes is illustrated in this overview. The corresponding programmes for your appliance can be found on the fascia. Type of utensils Type of soiling Programme Possible additional Programme sequence options Prerinse very adhesive burned- ±...
Additional options Washing the dishes * depending on model Programme data Additional options can be set with the The programme data (consumption buttons P. values) can be found in the summary of instructions. They refer to normal Ÿ Express Wash/ Speed conditions and the water hardness set value : .
Timer programming * To change the setting: – Rotate programme selector 0 until * depending on model the required value is indicated on the You can delay the start of the programme digital display @. in 1-hour steps up to 24 hours. –...
Changing the programme Maintenance and care When the START button 8 has been pressed, the programme cannot be A regular inspection and maintenance of changed. your machine will help to prevent faults. The only way a programme can be This saves time and prevents problems. changed is by Cancel programme (Reset).
Filters Spray arm The filters 1* keep large foreign objects Limescale and dirt from the rinsing water in the rinsing water away from the pump. may block nozzles and the bearing assemblies of the spray arm 1". These foreign objects may occasionally block the filters.
Waste water pump Troubleshooting Large food remnants in the rinsing water not retained by the filters may block the The majority of faults which could occur in waste water pump. The rinsing water is daily operation can be rectified by the then not pumped out and covers the filter.
... when the appliance is – Water is left in the appliance at the end of the programme. switched on – ( : ) Waste water hose The appliance does not start. is blocked or kinked. – The mains fuse has tripped. Filters blocked.
... on the utensils Plastic parts discoloured. – Too little/unsuitable detergent. Food residue on the utensils. – Too weak programme selected. – Utensils placed too closely together, Rust spots on the cutlery. utensils basket overfilled. – Cutlery not rust-resistant. – Too little detergent. –...
Customer service Installation If the advice given does not resolve your The dishwasher must be connected problem, please contact your customer correctly, otherwise it will not function service. Contact details can be found on properly. The specifications for the inlet the back cover of this instruction manual and outlet as well as the electrical or in the enclosed customer service list.
– Some models: Waste-water connection The plastic housing on the water – The required work sequence can be connection contains an electric valve, found in the installation instructions. If the connecting cables are in the supply required, fit a siphon with an drainage hose.
It is not recommended to connect Removing the appliance the appliance to hot water if the water Also observe the sequence of worksteps is supplied from an electric boiler. here. Setting hot water: – Disconnect the appliance from the – Close the door. power supply.
Waste disposal Both the packaging of new appliances and the old appliances themselves contain valuable raw materials and recyclable materials. Please dispose of the individual parts separated according to type. Please ask your dealer or inquire at your local authority about current means of disposal.