Table of Contents
Advertisement
en Troubleshooting
Fault
E:25 lights up.
E:27 lights up.
Another error code
appears on the dis-
play.
E:01 to E:30
Fault
Tableware is not dry.
38
Cause and troubleshooting
Wastewater pump is blocked.
Clean the wastewater pump.
▶
→ "Clean wastewater pump", Page 48
Cover of the wastewater pump is loose
Secure the cover of the Wastewater pump
▶
→ Page 48 so it clicks into position.
Mains voltage is too low.
This is not a fault on the appliance.
Contact an electrician.
1.
Have the mains voltage and electrical installation
2.
checked by an electrician.
A technical fault is present.
Press
.
1.
Unplug the appliance or switch off the fuse.
2.
Wait at least 2 minutes.
3.
Insert the mains plug of the appliance in a socket
4.
or switch on the fuse.
Switch the appliance on.
5.
If the problem occurs again:
6.
Press
.
‒
Turn off the water tap.
‒
Pull out the mains plug.
‒
Contact Customer Service → Page 49 and give
‒
the error code.
Cause and troubleshooting
No rinse aid used or dosage set too low.
Add Rinse aid → Page 24.
1.
Set the amount of rinse aid to be dispensed.
2.
→ "Setting the amount of rinse aid", Page 25
Programme or programme option has no drying
phase, or the drying phase is too brief.
Select a programme with drying, e.g. intensive,
▶
strong or ECO programme.
Some option buttons decrease the drying result, e.g
varioSpeed.
Water collects in recesses of the tableware or cutlery.
Advertisement
Table of Contents
