Page 2
Endurance, UNI/O, WiperLock and ZENA are trademarks of Microchip Technology Incorporated in the U.S.A. and other countries. SQTP is a service mark of Microchip Technology Incorporated in the U.S.A. All other trademarks mentioned herein are property of their respective companies.
Select the Help menu, and then Topics to open a list of available on-line help files. INTRODUCTION This chapter contains general information that will be useful to know before using the TC1303 DFN Adjustable Output Demo Board . Items discussed in this chapter include: • Document Layout • Conventions Used in this Guide •...
(void) user { ... RECOMMENDED READING This user's guide describes how to use TC1303 DFN Adjustable Output Demo Board. The following Microchip documents are available and recommended as supplemental reference resources. TC1303A/TC1303B/TC1303C Data Sheet, "500mA Synchronous Buck Regulator, + 300mA LDO with Power-Good Output"...
UVLO, overtemperature and overcurrent protection on both outputs. This chapter covers the following topics. • What is the TC1303 DFN Adjustable Output Demo Board? • What the TC1303 DFN Adjustable Output Demo Board Kit includes. TC1303C Buck Regulator 500mA Synchronous Buck...
TC1303 DFN Adjustable Output Demo Board User’s Guide WHAT IS THE TC1303 DFN ADJUSTABLE OUTPUT DEMO BOARD? The TC1303 DFN Adjustable Output demo board demonstrates the use of Microchip’s TC1303C device in applications that require dual supply voltage.The demo board is...
OUT2 GETTING STARTED The TC1303 DFN Adjustable Output Demo Board is fully assembled and tested for evaluating the TC1303C device. The board requires the use of an external input volt- age source of (2.7V to 5.5V) and maximum external load of 500 mA for buck regulator output and 300 mA for LDO regulator output.
Page 12
TC1303 DFN Adjustable Output Demo Board User’s Guide 4. The power-good output signal is available on the test point TP5 (PG). 5. The switch S1, position 1 and position 2 are used to determine the SHDN1 and SHDN2 modes for the TC1303C device.
Page 13
2.7V to 5.5V and checking the output voltage, the line regulation can be calculated. The best way to evaluate the TC1303 DFN Adjustable Output Demo Board is to dig into the circuit. Measure voltages and currents with a DVM and probe the board with an oscilloscope.
TC1303 DFN ADJUSTABLE OUTPUT DEMO BOARD USER’S GUIDE Appendix A. Schematic and Layouts INTRODUCTION This appendix contains the following schematics and layouts for the TC1303 DFN Adjustable Output Demo board: • Board – Schematic • Board – Top Silk Screen Layer •...
Need help?
Do you have a question about the TC1303 DFN and is the answer not in the manual?
Questions and answers