Page 2
Microchip products meet the specification contained in their particular Microchip Data Sheet. • Microchip believes that its family of products is one of the most secure families of its kind on the market today, when used in the intended manner and under normal conditions.
• Appendix A. “Schematic and Layouts” – Shows the schematic and layout diagrams for the MCP73830L 2x2 TDFN Li-Ion Battery Charger Evaluation Board. • Appendix B. “Bill of Materials” – Lists the parts used to build the MCP73830L 2x2 TDFN Li-Ion Battery Charger Evaluation Board.
MCP73830L 2x2 TDFN Li-Ion Battery Charger Evaluation Board User’s Guide CONVENTIONS USED IN THIS GUIDE This manual uses the following documentation conventions: DOCUMENTATION CONVENTIONS Description Represents Examples Arial font: ® Italic characters Referenced books MPLAB IDE User’s Guide Emphasized text ...is the only compiler...
Preface RECOMMENDED READING This user's guide describes how to use MCP73830L 2x2 TDFN Li-Ion Battery Charger Evaluation Board. Other useful documents are listed below. The following Microchip documents are available and recommended as supplemental reference resources. • MCP73830L Data Sheet - “Single-Cell Li-Ion/Li-Polymer Battery Charge Management Controllers in 2x2 TDFN”...
PROG current up to a maximum of 200 mA. This chapter covers the following topics: • “What is the MCP73830L 2x2 TDFN Li-Ion Battery Charger Evaluation Board?” • “What the MCP73830L 2x2 TDFN Li-Ion Battery Charger Evaluation Board Kit Includes.”...
MCP73830L that effectively charges Li-Ion batteries with high-accuracy, preset-voltage regulation. The MCP73830L 2x2 TDFN Li-Ion Battery Charger Evaluation Board comes with a pre-installed 2 mm x 2 mm TDFN-6 MCP73830L. This circuit is ready to charge Li-Ion batteries at a maximum charge current rate up to 200 mA.
The MCP73830L 2x2 TDFN Li-Ion Battery Charger Evaluation Board demonstrates Microchip's stand-alone Linear Li-Ion Battery Charger in a simple and compact design. The MCP73830L requires only a minimum number of components to implement a complete battery charge management circuit. The MCP73830L 2x2 TDFN Li-Ion Battery Charger Evaluation Board comes with a 6-pin TDFN MCP73830L pre-installed.
MCP73830L 2x2 TDFN Li-Ion Battery Charger Evaluation Board User’s Guide GETTING STARTED The MCP73830L 2x2 TDFN Li-Ion Battery Charger Evaluation Board is fully assembled and tested for charging a single-cell Li-Ion or Li-Polymer battery with an input supply of 3.75V to 6V.
CHARGER EVALUATION BOARD USER’S GUIDE Appendix A. Schematic and Layouts INTRODUCTION This appendix contains the following schematics and layouts for the MCP73830L 2x2 TDFN Li-Ion Battery Charger Evaluation Board: • Board – Schematic • Board – Top Layer • Board – Top Copper Layer •...
RES 2.00K OHM 1/8W 1% 0805 SMD Panasonic - ECG ERJ-6ENF2001V Single-Chip Linear Li-Ion Battery Charger Microchip Technology Inc. MCP73830L Note 1: The components listed in this Bill of Materials are representative of the PCB assembly. The released BOM used in manufacturing uses all RoHS-compliant components.
Need help?
Do you have a question about the MCP73830L and is the answer not in the manual?
Questions and answers