3.11 DID Card (KX-T96182)
KX-T96182
"DID" is marked.
1) Connection of the Central Office Line
View of TEL Jack (CO)
(L) and (H) are equipped for
the DID port No.4 only.
l
Insert this card into a free slot.
To Terminal Board or
Modular Jacks from the
Central Office (CO).
DID Port No.4
Use 2- conductor (See "Note" below.)
wiring cord
l
Insert the modular plug of the telephone line cord (2-conductor wiring) into the
modular jack on the DID card.
(Note)
The DID port No.4 is equipped with "H (High)" and "L (Low)" leads.
If you connect a 4-conductor wiring cord to this port, the on/off status of the system can be detected
through "H" and "L" leads.
When the system is on : Ground is applied.
When the system is off : Ground is not applied.
2-c-25
(10991)