Altronix SMP1012 Series Installation Manual

These units will convert a 115VAC 50/60Hz input into a regulated 12VDC output at up to 10 amp continuous supply
current (see specifications).

SMP1012X Series Power Supply Configuration Reference Chart:

Altronix
Model Number
SMP10C12X
SMP10C12XX*
SMP10PMC12X
SMP10PMC12XX*
SMP10PM12P4
SMP10PM12P4CB
SMP10PM12P8
SMP10PM12P8CB
SMP10PM12P16
SMP10PM12P16CB
*Refer to Enclosure Dimensions on pg.7 for enclosure size.

Battery Backup:

• Built-in charger for sealed lead acid or gel type batteries.
• Maximum charge current 0.7 amp.
• Filtered and electronically regulated outputs.
• Automatic switch over to stand-by battery when
AC fails (zero voltage drop).

Features:

• AC input and DC output LED indicators.
Wiring methods should be in accordance with the National Electrical Code/NFPA 70/NFPA 72/ANSI and with all local
codes and authorities having jurisdiction. Product is intended for indoor use only.
1. Mount unit in the desired location. Mark and predrill holes in the wall to line up with the top two keyholes in the
enclosure. Install two upper fasteners and screws in the wall with the screw heads protruding. Place the enclosure's
upper keyholes over the two upper screws; level and secure. Mark the position of the lower two holes. Remove the
enclosure. Drill the lower holes and install three fasteners. Place the enclosure's upper keyholes over the two
upper screws. Install the two lower screws and make sure to tighten all screws (Enclosure Dimensions, pgs. 6-7).
Secure enclosure to earth ground.
2. Connect AC power to the terminals marked [L & N].
Use 18 AWG or larger for all power connections (Battery, DC output).
3. Measure output voltage before connecting devices. This helps avoiding potential damage.
SMP1012Xseries
All manuals and user guides at all-guides.com
SMP1012X Series - Installation Guide
Accessory
Power
Distribution
Module(s)
- 1
- 1
- 1
- 1
PD4 4
PD4CB 4
PD8 8 x
PD8CB 8
PD16W 16 x
PD16WCB 16

Installation Instructions:

Overview:

- - 10 - 1.45
- - 10 - 1.45
- - 10 x 1.45
- - 10 x 1.45
- 3.5 x 1.45
- x 2.5 x 1.45
- 3.5 x 1.45
- x 2.5 x 1.45
- 3.5 x 1.45
- x 2.5 x 1.45

Specifications:

Features (cont'd):
• Short circuit and thermal overload protection.
• Complete with power supply, power distribution module
(when applicable), enclosure, cam lock & battery leads.
• Power ON/OFF switch.
Supervised models only:
• AC fail supervision (form "C" contacts).
• Low battery supervision (form "C" contacts).
10
10
10
10
10
10
10
10
10
10
- 1 -