Controls And Indicators; Reset (System Reset); Network Reset Option (Ip Settings) - d&b audiotechnik 40D Reference Manual

d&b 40D Reference manual 1.3 en

5.3 Controls and indicators

5.3.1 RESET (System reset)

A reset button (RESET [8]) is located on the rear panel next to the
digital LINK D3/D4 connector terminal.
To prevent accidental system reset, the button is slightly recessed.
To perform a system reset, proceed as follows:
Note: All device preferences will be set to factory defaults
except for the network and fixed device settings.
1. Isolate the device from mains power by releasing the
powerCON connector and turn it counterclockwise.
2. Press and hold the «RESET» button using an appropriate pen.
3. While holding the «RESET» button pressed, repower the
device by turning the powerCON connector clockwise.
↳ Long confirmation beep.
4. Release the «RESET» button and briefly press the button again
within 2 sec.
↳ Short confirmation beep Þ the device will reboot.

5.3.1.1 Network reset option (IP settings)

Executing the following reset procedure allows you to locally
change/edit the network (IP) settings, if required.
Once the settings have been changed and the device has been
shut down, the access to the network settings will be disabled
again after repowering the device.
1. During normal operation, press and hold the «RESET» button
for 5 sec.
↳ Long confirmation beep.
2. Release the «RESET» button and briefly press the button again
within 2 sec.
↳ Short confirmation beep.
The network settings will become accessible for editing by
tapping the «Network» navigation button as shown in the
graphic opposite.
Startup
19