Electrolux EB6GL70KCN User Manual page 28

Problem
The display shows an error code
that is not in this table.
Steam and condensation settle on
the food and in the cavity of the
oven.
The appliance is activated and does
not heat up. The fan does not oper‐
ate. The display shows "Demo".
The descaling procedure is interrup‐
ted before it finishes.
The descaling procedure is interrup‐
ted before it finishes.
There is no water inside the grill- /
roasting pan after the descaling pro‐
cedure.
There is dirty water on the bottom of
the cavity after the descaling cycle.
The cleaning function is interrupted
before it finishes.
The cleaning function is interrupted
before it finishes.
There is too much water on the bot‐
tom of the cavity after the end of the
cleaning function.
There is no good performance of the
cleaning procedure.
There is no good performance of the
cleaning procedure.
There is no good performance of the
cleaning procedure.
28 ENGLISH
Possible cause
There is an electrical fault.
You left the dish in the oven for too
long.
The demo mode is activated.
There was a power cut.
The function was stopped by the
user.
You did not fill the water drawer to
the maximum level.
The grill- / roasting pan is on a
wrong shelf position.
There was a power cut.
The function was stopped by the
user.
You sprayed too much detergent in
the appliance before the activation
of the cleaning cycle.
The initial oven cavity temperature
of the steam cleaning function was
too high.
You did not remove the side grids
before the start of the cleaning pro‐
cedure. They can transfer heat to
the walls and decrease the perform‐
ance.
You did not remove the accessories
from the appliance before the start
of the cleaning procedure. They can
compromise the steam cycle and
decrease the performance.
Remedy
• Turn off the oven with the house
fuse or the safety switch in the
fuse box and turn it on again.
• If the display shows the error
code again, contact the Custom‐
er Care Department.
Do not leave the dishes in the oven
for longer than 15 - 20 minutes after
the cooking process ends.
Refer to "Daily Use chapter, Basic
Settings.
Repeat the procedure.
Repeat the procedure.
Check if the a descaling agent / wa‐
ter is present in the water drawer
body.
Repeat the procedure.
Remove the residual water and the
descaling agent from the bottom of
the oven. Put the grill- / roasting pan
on the first shelf position.
Repeat the procedure.
Repeat the procedure.
Cover all parts of the cavity with a
thin layer of the detergent. Spray the
detergent evenly.
Repeat the cycle. Run the cycle
when the appliance is cold.
Remove the side grids from the ap‐
pliance and repeat the function.
Remove the accessories from the
appliance and repeat the function.