Operation; User Manual - Magio MG-336 Instruction Manual

EN

Operation

1. Make sure that the operating voltage of the appliance corresponds to the voltage of the
network.
2. Hold the water tank and turn the garment steamer handle around.
3. Remove the water tank, open the water inlet valve and fill with water up to the MAX mark. Do
not use hot water! It is better to use distilled water to extend the life of the appliance.
4. Close the valve and connect the water tank to the garment steamer body by turning in the
opposite direction.
5. Monitor the water level to prevent water shortages during use. Using the device without
water in the tank is strictly forbidden!
6. If it necessary, install the nozzle.
7. Unscrew the power cord for the entire length and insert the power cord plug into the wall
outlet.
8. Press the on/off button. The indicator light will start flashing. Wait until the indicator stops
flashing. The device has warmed up and is ready to work.
9. Press the steam button and let the first steam out before starting, as it may contain water
droplets.
10. For continuous steam supply, fix the steam supply button with a lock.
11. Change the steam intensity by pressing the on/off button. You can also use this button to
activate standby mode.
12. To turn off the device, press and hold the on/off button.
13. Disconnect the appliance from the power supply.
14. After about 30 minutes, when the appliance has cooled down, empty the water tank and put
the appliance for storage.
Note
This appliance is equipped with a water shortage protection function. When the water
level in the water tank falls below the minimum level, the pump automatically stops
after 30-50 seconds and the yellow water low indicator light turns on. This feature
extends the service life of the pump and the appliance.
Warning!
»
Do not turn on the device without water.
»
Before filling water, please pull out the plug first.
»
Use only distilled water for pour into the water tank. Do not fill the water tank beyond the
MAX indication.
»
Do not use hot water, the water temperature should not be higher than +50 °C.
»
Do not add perfume, vinegar, magnetically treated water, starch, descaling agents, ironing
aids, chemically descaled water or other chemicals as they may cause water spitting, brown
staining or damage to your appliance.
»
Do not use your bare hand as a supporting surface when you steam.

User manual

- The appliance can be used for creating a natural look and for quick touch-ups. For garments with
tough wrinkles and for a more formal look, it is recommended to use an iron instead.
- You can wrinkle garments more easily if you spread the laundry properly after you have washed
it. Hang the garments on hangers to dry them with fewer wrinkles.
- When you are steaming, press the steamer head against the garment, and pull the sides of the
garment with your other hand to stretch it.
- Keep the steamer head a slight distance away from dresses with frills, ruffles, ruching or sequins.
17