Table of Contents
Advertisement
16.12 Frost precautions
If the appliance is installed in an area where
the temperature can reach values around 0°
C or drop below, remove the remaining water
from the inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of the
hose.
17. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
17.1 Alarm Codes and Possible failures
The appliance does not start or it stops during operation. First try to find a solution to the problem
(refer to the tables).
WARNING!
Deactivate the appliance before carrying out any check.
With some problems, the display shows an alarm code and the Start /
Pause
button may flash continuously:
If the appliance is overloaded, remove some items from the drum
and/or keep pressed the door while touching the Start / Pause
button until the indicator
4. Empty the drain pump. Refer to the
5. When the drain pump is empty, install the
stops flashing (see the picture below).
emergency drain procedure.
inlet hose again.
WARNING!
Make sure that the temperature is higher
than 0 °C before you use the appliance
again.
The manufacturer is not responsible for
damages caused by low temperatures.
ENGLISH
49
Advertisement
Table of Contents
